Log; Confirmable Log Files From Management Module - Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual

Check the command (1) including (2) and (3) in the contents. (2) shows the
cause of the failure after Command was canceled.
2. Correct the file referring to the import result file, recreate it, and execute
the import again.
Failed writing to result file.
An import result file, importresult-yyyymmddhhmmss.txt, failed to be written
onto the USB flash drive that contains the import file.
1. Check that the USB flash drive is inserted into the server chassis. Also
check the residual capacity of the USB flash drive. The maximum import file
is up to 5 KB.
Specified file is not defined.
1. Check that the USB flash drive, which has been specified at import
execution, is inserted into the server chassis. Then, execute import again.
Unexpected error occurred.
An error occurred in the controller that executes import. Consult your
reseller.
When any other message is shown, consult your reseller.

Log

This section describes logs from management modules and server blades.

Confirmable log files from management module

The following table shows the confirmable log files from management
module.
Log file name
System event log
(SEL)
Optional Physical
WWN change log
Optional Physical
MAC change log
MAR log
2-262
Hitachi Compute Blade 500 Series Management Module Setup Guide
Table 2-140 Confirmable log file
Recording the events occurred in the system unit.
The event types are failure, caution, and information.
Recording the change history of the Optional Physical WWN.
For more details about Optional Physical WWN, see
for Optional Physical WWN and MAC address on page
Recording the change history of the Optional Physical MAC
address.
For more details about Optional Physical MAC address, see
Change log for Optional Physical WWN and MAC address on page
2-62.
Recording the events caused the notification of failure.
Functional detail
Description
Change log
2-62.