BMC
LPAR manager cooperation function
This topic describes the procedures enabling LPAR manager usage. The
following procedure sets the parameters for LPAR manager installation,
configuration, and operation.
Confirm the following settings before operating the functions explained in this
section.
•
Setting an IP address to a server blade
•
Cable connecting to the System unit
•
Setting the EFI
For the settings above, see the Hitachi Compute Blade 500 Series Server
Blade Setup Guide.
For the functional list of Web console and HVM Navigator, see the following
table.
Perform the functions which are not supported on Web console on HVM
Navigator.
Initializing LPAR manager
Synchronizing LPAR manager System
Time with NTP server
Selecting LPAR manager firmware
Confirming virtual WWN
Confirming virtual MAC address
Turning on server blade
Configuring LPAR
Adding LPAR
Setting number of processors assigned to
LPAR
2-110
Hitachi Compute Blade 500 Series Management Module Setup Guide
Item
Creating CSR
Importing
certificate
Table 2-100 Functional List of Web console and HVM Navigator
Function
Functional detail
Operation
Resources tab > Modules > All modules >
Server Blade > Server Blade x > BMC tab > Edit
> Edit certificate
Resources tab > Modules > All modules >
Server Blade > Server Blade x > BMC tab > Edit
> Edit certificate
Web console
Y
-
Y
1
Y
Y
1
Y
2
Y
2
Y
2
Y
HVM Navigator
V02-04 or later
-
Y
-
Y
Y
-
Y
Y
Y