Table of Contents
Advertisement
S-7
S-7
General Description
This feature permits a call to be processed automatically through a hunt group of busy extensions, in a
programmed order.
Operating Procedure
No manual operation is required.
Service Conditions
1.
When all stations within a Circular Hunt Group are busy, the calling party will receive a Busy
Tone.
2.
Assignment of station numbers to a Circular Hunt Group may be in any order.
3.
This feature will be activated whenever the hunt group is dialed by the Attendant or another
station within the system.
4.
Calls to the first programmed station in a Circular Hunt Group will proceed through all other
programmed stations in the order they were programmed upon encountering a busy station, until
reaching the last.
5.
Calls directed to any other number in the Circular Hunt Group will proceed in the same manner
as calls to the first programmed number.
6.
If a HUNT group station has set CALL FORWARDING-ALL CALLS [C-5], hunting will bypass that
station and continue in the order of hunting.
7.
The maximum number of stations per group is 20. One group may have 40 stations.
8.
There is no limit on the allowable number of Circular Hunt Groups within an NEAX2400 ICS
system.
9.
In a Circular Hunt Group, one station can be designated as a secretarial station, thereby always
being the last station in the hunting sequence.
10. CALL FORWARDING-BUSY LINE [C-2]/ALL CALLS [C-5] are activated first rather than
STATION HUNTING-CIRCULAR, if the dialed station has set this feature.
11. The terminating sequence of service features to a station is as follows:
CALL FORWARDING - ALL CALLS
CALL FORWARDING - BUSY LINE
STATION HUNTING
CALL WAITING - ORIGINATING
CALL WAITING - TERMINATING
12. Recall from CALL BACK [C-1], OUTGOING TRUNK QUEUING [O-2] and PAGING TRANSFER
[P-10] will not hunt.
13. One station can belong to only one station hunt group (either Circular or Terminal).
14. This feature will be activated whenever the hunt group is dialed or terminated under the following
conditions:
a.) Dialed from a station,
b.) Dialed from ATTENDANT CONSOLE [A-3],
c.) Dialed from DID [D-8],
d.) Dialed from TIE LINE [T-3],
Page 456
Station Hunting - Circular
Station Hunting - Circular
[C-5]
[C-2]
[S-7, 8, 9]
[C-31]
[C-12]
NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Advertisement
Table of Contents
