Table of Contents
Advertisement
A-7
Service Conditions (cont'd)
3.
ATTENDANT OVERRIDE and ATTENDANT LOCKOUT [A-5] are mutually exclusive features.
4.
Each tone burst is 0.08 seconds in duration and is used to alert both parties that the Attendant
is overriding the conversation.
5.
This feature can be denied on DICTATION [D-3] and PAGING [P-1] connections by assigned
ARTD data.
6.
It is possible, via System Data, to completely disable the continuous sending of Warning Tone
during an ATTENDANT OVERRIDE connection. Normally the two burst Warning Tone is sent
when the ATTENDANT OVERRIDE connection is initiated and then is repeated approximately
every 15 seconds. The initial tone burst is also disabled. If the trunk is connected to a D
display is as follows:
term
D
Series E
After 5 seconds, the display returns to the normal Conference display, CNF.
7.
ATTENDANT OVERRIDE is temporarily denied and Reorder Tone heard if any of the following
features are active:
a.) EXECUTIVE RIGHT-OF-WAY [E-1]: If the called trunk is connected to a line on which
EXECUTIVE RIGHT-OF-WAY is being used.
b.) Trunk Restriction: If the called tie trunk was routed to Reorder Tone as a result of trunk
restriction.
c.) SPECIAL DIAL TONE [S-2]: If the called trunk is on hold.
d.) ATTENDANT CAMP-ON WITH TONE INDICATION [A-1]: If the called trunk is camped-
on to a busy station.
e.) SERIAL CALL [S-15]: ATTENDANT OVERRIDE is denied to the parties held on the
console.
f.) ATTENDANT INTERACTION: During the normal operation of PBX features, situations
may arise whereby a trunk may be connected to an ATTENDANT CONSOLE [A-3].
While the trunk is connected to the ATTENDANT CONSOLE [A-3] or is in queue at an
ATTENDANT CONSOLE [A-3], the Attendant at the Console or an Attendant at any
other Console (when multiple consoles are provided) is not allowed to bridge on the
connection. The trunk must be connected to a station in a talking mode in order for the
ATTENDANT OVERRIDE feature to function.
Interactions
1.
With ATTENDANT OVERRIDE, the following trunk types may be verified (busy or idle status):
a.) One-way incoming trunks
b.) One-way outgoing trunks
c.) Bothway trunk
2.
Trunks in a station-to-trunk connection or TRUNK-TO-TRUNK CONNECTION [T-10], and
ATTENDANT CONTROLLED CONFERENCE [A-2] can be verified when busy.
Page 14
Attendant Override
BV
(Time Display)
OPE BV
(Time Display)
OPR
NEAX2400 ICS Business Features and Specifications
term
, the
NDA-24143, Issue 4
Advertisement
Table of Contents
