Using The Wiper/Washer (Bosch Protocol) - Bosch MIC612 Operation Manual

74 en | Common User Commands
11.3

Using the Wiper/Washer (Bosch Protocol)

The "predefined position" for the wash/wipe function is preset 62. The installer must define
preset 62 (preferably where the washer nozzle is located and can direct washer fluid towards
the camera window) before using the wiper/washer function.
To activate the washer/wiper function, press ON-105-ENTER, and then confirm this
sequence:
1.
2.
3.
4.
To activate intermittent wipe:
Press ON-103-ENTER. The wiper wipes twice, then returns to parked position, and then turns
off 15 seconds later. This sequence will continue for up to 5 minutes or until an OFF-103-
ENTER command is sent.
To activate continuous wipe:
Press ON-102-ENTER. The wiper wipes continuously for up to 5 minutes, or until another
OFF-102-ENTER command is sent (if the command is sent before the 5 minutes elapse). The
wiper then turns off automatically.
To activate the wiper to wipe five (5) times:
Press ON-104-ENTER. The wiper wipes five (5) times, or until an OFF-104-ENTER command is
sent (if the command is sent before the wiper wipes five (5) times), then returns to parked
position and turns off.
2016.03 | 2.1 | F.01U.249.416
The wiper moves to a predefined position.
The washer turns on for five seconds. Simultaneously, the wiper turns on and wipes five
times.
The washer turns off. The wiper continues wiping for five more wipes as the camera
returns to its initial PTZ position (and to inactive mode if applicable).
The wiper turns off.
Operation Manual
MIC612 Thermal Camera
Bosch Security Systems