Toshiba e-STUDIO182 Service Manual page 85

• The ADU sensor (on the ADU board) does not detect paper in a fixed period of time when the
paper is transported within the ADU.
Paper jam (E51)
• Registration sensor detects jamming of the leading edge of paper:
Registration sensor is not turned ON in a fixed period of time after the feeding starts.
Paper jam (E12, E13, E21, E30 and E33)
(The error code differs depending on the paper source. Refer to the error code table in Service
Handbook.)
• The PFU paper feed sensor is not turned ON in a fixed period of time after the pickup solenoid is
turned ON.
Paper jam (E14)
• The PFP upper drawer feed sensor is not turned ON in a fixed period of time after the paper feed
clutch is turned ON when paper is fed out of the PFP.
Paper jam (E15 and E36)
• The PFP lower drawer feed sensor is not turned ON in a fixed period of time after the paper feed
clutch is turned ON when paper is fed out of the PFP.
Paper jam (E16)
• The PFU feed sensor is not turned ON in a fixed period of time after the paper feed clutch is turned
ON when paper is fed out of the PFP.
Paper jam (E32 and E35)
(The error code differs depending on its paper source. Refer to the error code list in the Service
Handbook.)
(D) Replace the toner cartridge
• Toner density becomes low
Auto-toner sensor detects the absence of the toner
Control circuit The toner lamp brinks: the copying operation disabled
Solution: Open the front cover and replace the toner cartridge with a new one.
Toner is supplied
© 2009 TOSHIBA TEC CORPORATION All rights reserved
copying operation enabled.
4 - 9
e-STUDIO182/212/242
GENERAL OPERATION
4