12.6.9
Center thermistor / Side thermistor / Edge thermistor (THMS1/
THMS2/THMS3)
(1)
Take off the fuser roller.
P.12-20 "12.6.7 Fuser roller"
(2)
Remove each 1 screw of the thermistors,
and then take off each thermistor by
releasing its harness out of the harness
clamp.
Note:
When installing the thermistors, do not mix
up the installation positions of the side
thermistor and the edge thermistor by telling
them apart by the length of their harnesses.
12.6.10 Fuser thermostat (THMO1)
(1)
Take off the fuser roller.
P.12-20 "12.6.7 Fuser roller"
(2)
Remove 2 screws and take off the fuser
thermostat.
e-STUDIO182/212/242
FUSER / EXIT UNIT
Thermistor
Side thermistor
Center thermistor
© 2009 TOSHIBA TEC CORPORATION All rights reserved
12 - 22
Fig. 12-34
Edge thermistor
Fig. 12-35
Fuser thermostat
Fig. 12-36