10.7.2
Drum cleaner unit
(1)
Take out the process unit.
P.10-9 "10.7.1 Process unit"
(2)
Disconnect 2 connectors and remove 2
screws.
(3)
Release 1 latch. Then pull out the process
unit front cover and take it off.
Note:
When installing the process unit front cover,
wire the harness correctly in order not to
contact the gears and harness of the process
unit front cover each other.
© 2009 TOSHIBA TEC CORPORATION All rights reserved
for MJD
Latch
Process unit front cover
Fig. 10-10
except for MJD
Latch
Process unit front cover
Fig. 10-11
Harness
Process unit
front cover
Fig. 10-12
10 - 11
Connector
Connector
Connector
Connector
e-STUDIO182/212/242
DRUM RELATED SECTION
10