Disassembly And Replacement - Toshiba e-STUDIO182 Service Manual

7.5

Disassembly and Replacement

7.5.1 Laser optical unit
(1) Take off the rear cover.
P.2-21 "2.5.10 Rear cover"
(2) Disconnect 3 connectors from the MAIN
board.
Note:
Connect the flat harness to the MAIN board
with its erectrode side down. An error "CA2"
will be displayed if the connection is
incorrect.
(3) Take off the switching regulator unit.
P.2-25 "2.6.5 Switching regulator unit
(PS)"
(4) Remove 1 screw.
(5) Pull out the laser optical unit while lifting it up
and take it off.
© 2009 TOSHIBA TEC CORPORATION All rights reserved
Connector
Fig. 7-10
Laser optical unit
Fig. 7-11
7 - 7
Connector
e-STUDIO182/212/242
LASER OPTICAL UNIT
7