Installing The Roll Bar; Installing The Seat; Installing The Steering Wheel - Toro Greensmaster 3420 TriFlex Operator's Manual

1

Installing the Roll Bar

Parts needed for this procedure:
1 Roll bar
4 Bolt (1/2 x 3-3/4 inches)
4 Flange-nut (1/2 inch)
Procedure
1. Remove the top crate support from the crate.
2. Remove the roll bar from the crate.
3. Install the roll bar into the pockets on each side of the
machine, using 4 bolts (1/2 x 3-3/4 inches) and four
flange-nuts (1/2 inch) (Figure 3)
1. Roll bar
2. Bolt (1/2 x 3-3/4 inches)
4. Torque the fasteners to 100 to 110 ft-lb (136 to 149
N-m).
1
2
3 g014601
Figure 3
3. Flange-nut (1/2 inch)
2

Installing the Seat

Parts needed for this procedure:
1 Seat completion kit
Procedure
Acquire your desired seat kit from your distributor and install
it as directed in the instruction included with the kit.
3

Installing the Steering Wheel

Parts needed for this procedure:
1 Steering wheel
1 Locknut (1-1/2 inches)
1 Washer
1 Steering wheel cap
Procedure
1. Slide the steering wheel onto the steering shaft
(Figure 4).
1. Steering wheel
2. Washer
2. Slide the washer onto the steering shaft (Figure 4).
3. Secure the steering wheel to the shaft with a jam nut
and tighten it to 20 to 26 ft-lb (27 to 35 N-m) (Figure 4).
4. Install the cap to the steering wheel and secure it with a
screw (Figure 4).
12
Figure 4
3. Jam nut
4. Cap