Toro Greensmaster 3420 TriFlex Operator's Manual page 20

Main Menu
Menu Item
Faults
Service
Diagnostics
Settings
About
Service
Menu Item
Hours
Counts
Diagnostics
Menu Item
Engine Run
Glowplugs
Fan
S1–S4
Reels Enable
Description
The Faults menu contains
a list of the recent machine
faults. Refer to the Service
Manual or your Authorized Toro
Distributor for more information
on the Faults menu and the
information contained there.
The Service menu contains
information on the machine
such as hours of use and other
similar numbers.
The Diagnostics menu lists
various states that the machine
currently has. You can use this
to troubleshoot certain issues
as it will quickly tell you which
machine controls are on and
which are off.
The Settings menu allows
you to customize and modify
configuration variables on the
InfoCenter display.
The About menu lists the
model number, serial number,
and software version of your
machine.
Description
Lists the total number of hours
that the machine, engine,
reels, backlap, and fan have
been on, as well as the number
of hours the machine has been
transported and overheated.
Lists the number of preheats
and starts the machine has
experienced.
Description
Indicates if the following items
are active: Key start, key run,
joystick lower, joystick raise,
neutral, seat or parking brake,
OK run, and RTR or ETR.
Indicates if the following items
are active: Key start, timeout
limited, and glowplugs.
Indicates if the fan is active
in the following instances:
Engine high temp, oil high
temp, engine or hydraulic high
temp, and fan on.
Controls the raising and
lowering of the solenoids.
Indicates if the eReel is
enabled.
Settings
Menu Item
Units
Language
LCD Backlight
LCD Contrast
Protected Menus
Protection Settings
Reset Defaults
Raise Delay
Lower Delay
Tapoff Delay
Reel Speed
Backlap RMP
About
Menu Item
Model
SN
TEC 5001
InfoCenter
CU1
CU2
CU3
Generator
CAN Bus
Center Cutting Unit Raise/Lower Delay
The raise and lower delay time for the center cutting may be
adjusted independently with the InfoCenter. Each setting
may be adjusted from 1 to 10 according to the table below.
20
Description
Controls the units used on the
InfoCenter. The menu choices
are English or Metric.
Controls the language used on
the InfoCenter.
Controls the brightness of the
LCD display.
Controls the contrast of the
LCD display.
Allows the distributor/engineer
to access protected menus by
inputting a passcode.
Controls the protected menus.
Resets the InfoCenter to
default settings.
Controls the raise delay time
for the center cutting unit.
Controls the lower delay for the
center cutting unit.
Controls the tap-off delay.
Controls the reel speed.
Controls the backlap RPM
speed.
Description
Lists the model number of the
machine.
Lists the serial number of the
machine.
Lists the software revision of
the master controller.
Lists the software revision of
the InfoCenter.
Lists the software revision of
the first cutting unit.
Lists the software revision of
the second cutting unit.
List the software revision of the
third cutting unit.
Lists the serial number of the
generator.
Lists the machine
communication bus status.