Panasonic KX-TDA100 Programming Manual page 95

Setting Features
Q How do I change the dialling mode of an analogue trunk?
A •
From the 3.11 [1-1] Slot—Port Property - LCO Port screen, change the
Mode setting of the target port to "DTMF" or "Pulse", as required.
Q How do I set disconnect detection (CPC Detection) for an analogue trunk?
A •
From the 3.11 [1-1] Slot—Port Property - LCO Port screen, modify the
Signal Detection Time—Outgoing, Incoming setting of the target port.
The required value varies by carrier. Transmission and reception can be set separately.
Q What settings do I change to enable use of an extension ISDN telephone?
A •
From the 3.14 [1-1] Slot—Port Property - BRI Port screen, set the
the port you want to use to "Extension".
Q When using a TE with an extension ISDN, how do I enable power output?
A •
From the 3.14 [1-1] Slot—Port Property - BRI Port screen, set
on the ISDN Extension tab to "Enable".
Q How do I connect to another PBX using QSIG?
A •
From the 3.14 [1-1] Slot—Port Property - BRI Port or 3.16 [1-1] Slot—Port Property
- PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only) screen, set the
Type of the port you want to use to either "QSIG-Slave" or "QSIG-Master".
Q How do I change the type of an extension port?
A •
Set the port to OUS status. Then, change
Port Property - Extension Port window
Q I have set the type of an extension port to "DSS Console", but I cannot apply this
setting. (Error E000402)
A •
The number entered in
Property - Extension Port screen is the same as that entered for another DSS
Console. Change this so that the numbers do not overlap.
Q I have set the type of an extension port to "VM (DPT)", but I cannot apply this setting.
(Error E000403)
A •
The DPT Type—VM Unit No. and
the 3.5 [1-1] Slot—Port Property - Extension Port screen are the same as those
entered for another VM (DPT). Change this so that the numbers do not overlap.
Q I have set the type of an extension port to "PC Console", but I cannot apply this
setting. (Error E000402)
A •
The number entered in
Property - Extension Port screen is the same as that entered for another PC Console.
Change this so that the numbers do not overlap.
Q What programming do I have to perform to use a headset with an extension?
DPT Type—Type in the 3.5 [1-1] Slot—
DPT Type—Location No. on the 3.5 [1-1] Slot—Port
DPT Type—VM Port No. settings entered on
DPT Type—Location No. on the 3.5 [1-1] Slot—Port
2.7.1 Frequently Asked Questions (FAQ)
Dialling
CPC
Port Type of
ISDN TE Power
Port
PC Programming Manual 95