Panasonic KX-TDA100 Programming Manual page 62

2.6.1 Utility—Diagnosis
Test Type
Caller ID Card DTMF Sending Out
Diagnosis
DSP DTMF generator/receiver
diagnosis
DSP DTMF receiver diagnosis
Framer IC alarm signal detection
diagnosis
Framer IC error detection diagnosis
CS-INF loop back diagnosis
Super frame synchronization
diagnosis
Caller ID card loop back diagnosis
Extension mode setting test
CTI-LINK loop back diagnosis
IP-GW H.323 call simulate diagnosis IP-GW4 (KX-TDA0484), IP-GW16
LAN loop back diagnosis
To perform a card test
1.
From the Utility menu, select Diagnosis.
2.
Click on the Status cell of the card to be tested, and set it to "OUS".
With the KX-TDA30, to perform the EXT-CID path test, set the status of both the EXT-CID card and the
card in slot 1 to "OUS".
3.
Click on the cell showing the card type.
A new window will be displayed.
4.
Select the Card Test option.
A new window will be displayed.
5.
Click Test to perform the test(s).
The error report will be displayed. When all tests are completed, the words "Test End!" will be shown on
the last line of the output.
6.
Select an option:
•
Click Capture if you want to save the displayed information.
1.
Enter a file name, or select a file to overwrite.
2.
Click Save.
•
Click Cancel to return to the Diagnosis screen.
Pair Port Test (KX-TDA100/KX-TDA200/KX-TDA600 only)
Tests the combination of an extension port and trunk port to ensure that communication with the trunk port can
be carried out successfully.
The pair port test can be carried out using one LCOT or ELCOT card and one DHLC, SLC8, SLC16,
MSLC16, ESLC16 or EMSLC16, CSLC16, or ECSLC24 card.
62 PC Programming Manual
SLC8
T1, E1
T1, E1
T1, E1, PRI
T1, E1, PRI
CSIF
CSIF
LCOT, ELCOT
BRI
CTI-LINK
IP-GW4 (KX-TDA0484)
Available Cards