GE DVSR xU User Manual page 47

DVSR xU User Manual
Figure 33: The motion alarm Rules submenu
b. Go to the Record Camera check boxes and select the cameras from which you want to be
able to record a motion alarm. Press Enter or left-click the mouse to enable the option. Press
or click again to disable.
Note: For the cameras to be able to record a motion alarm, they must first be setup for motion
recording. This is done in the Recording menu. See page 53 for more information.
c. Go to Alarm Schedule and select when you want the DVSR xU to respond to a motion alarm.
You can select up to seven days in a week and up to four time periods for each a day.
Note: The four daily time periods cannot overlap.
d. Go to the notification options and press Enter or left-click the mouse to enable () or disable
how you want the DVSR xU to respond to a motion alarm during live mode.
Table 10: Notification options on how to respond to a camera tamper alarm
Notification option
Alarm Out
Buzzer
TCP
Full Screen
Email
The DVSR xU returns to live mode when there is no longer a motion alarm.
e. If you want to copy the periods from one camera to another, go to the Copy to list box and
select which day you want to copy to and then select Copy.
4. Select OK to confirm the changes and to return to the Camera menu.
Reponse
Alarm Out is activated. Up to four alarm outputs can be enabled.
An audible alarm sounds
Alarm information is sent to the remote IP (see section Network on page 60
for more information)
The alarm channel will be displayed on screen
Alarm information is sent to an e-mail address (see section Network on
page 58 for more information)
43