Focus Adjustment - Sanyo PLC-XP200L Service Manual

Optical Parts Disassembly
Note on LCD Panel/Prism Ass'y Mounting
After replacing or installing the LCD Panel/Prism ass'y, please make
sure to obtain the best focus in both TELE and WIDE zoom. If the
focus adjustment is required, please adjust the positioning of LCD
Panel/Prism Ass'y following to the procedure below.

Focus adjustment:

1 Loosen 4 screws A on the LCD Panel/Prism ass'y with .0 mm hex
driver.
 Turn the projector on and project the image with WIDE zoom, and
adjust the FOCUS control to obtain the best focus.
3 Turn the ZOOM control to the TELE position.
4 Insert a flat screw driver into the slot B and move the LCD Panel/
Prism Ass'y backward or forward by turning the screwdriver left
or right to obtain the proper focus. Confirm the focus at TELE and
WIDE zoom.
5 Tighten 4 screws A to fix the LCD Panel/Prism ass'y.
B
-3-
A
A