Lamp Replacement - Sanyo PLC-XP200L Service Manual

Maintenance

Lamp Replacement

When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the screen
and LAMP REPLACE indicator lights orange. Replace the lamp with a new one promptly. The timing when the LAMP
REPLACE indicator should light is depending on the lamp mode.
Top Panel
LAMP REPLACE indicator
Follow these steps to replace the lamp.
1
Turn off the projector and unplug the AC power cord.
Let the projector to cool for at least 45 minutes.
2
Open the filter cover.
3
Loosen the screw and open the lamp cover and pull
out the lamp by using the built in handle.
4
Replace the lamp with a new one. Make sure that
the lamp is properly and fully inserted.
5
Close the lamp cover and secure the screw, and
close the filter cover.
6
Connect the AC power cord to the projector and turn on
the projector.
7
reset the Lamp replacement counter
Note:
• Be sure to insert the lamp in the correct direction.
• Do not reset the Lamp replacement counter when the pro-
jection lamp is not replaced.
CAUTION
Allow a projector to cool for at least 45 minutes
before you open the lamp cover. The inside of the
projector can become very hot.
CAUTION
For continued safety, replace with a lamp of the
same type. Do not drop the lamp or touch the glass
bulb! The glass can shatter and may cause injury.
Lamp replacement icon
Filter cover
order rePLAceMeNt LAMP
type No.
Service Parts No.
-11-
Lamp cover
Handle
Lamp
PoA-LMP124
610 341 1941