Adjusting The Foot Shift Switch - Yamaha 2006 FJR1300AS Service Manual

Shift pedal pivot bolt
16 Nm (1.6 m·kg, 11 ft·lb)
LOCTITE
NOTE:
• Position the projection "a" on the shift pedal be-
tween the ends "b" of the spring on the left foot-
rest assembly.
• Be sure to fit the projections "c" on the shift
pedal pivot into the holes "d" in the left footrest
assembly.
5
6
7
c
a
3 2
4
3. Install:
• Holder "1"
• Foot shift switch "2"
NOTE:
• Be sure to align the cutouts "a" in the holder
with the projections "b" on the shift pedal pivot.
• Fit the foot shift switch onto the holder, and
then rotate the switch counterclockwise and
temporarily install the screws. Be sure to fit the
section "c" of the holder into the opening "d"
shown in the illustration.
b
2
d
®
d
b
1
b
1
a
a
b
SHIFT ACTUATOR AND SHIFT ROD
4. Adjust:
• Foot shift switch
Refer to "ADJUSTING THE FOOT SHIFT
SWITCH" on page 60.
ET2D21010

ADJUSTING THE FOOT SHIFT SWITCH

1. Check:
• Foot shift switch
Refer to "CHECKING THE FOOT SHIFT
SWITCH" on page 133.
2. Adjust:
• Foot shift switch angle
M MMM M MMM M
a. Connect the foot shift switch coupler to the
foot shift switch.
b. Connect the digital circuit tester to the foot
shift switch coupler.
• Positive tester probe →
orange "1"
• Negative tester probe →
black "2"
c. Turn the main switch to "ON".
d. Measure the foot shift switch voltage.
e. Adjust the foot shift switch angle so that the
voltage is within the specified range.
c
f. After adjusting the foot shift switch angle,
tighten the foot shift switch screws "3" to
specification.
– 60 –
M MMM M M MMM M M MMM M
Digital circuit tester
90890-03174
Model 88 Multimeter with ta-
chometer
YU-A1927
Output voltage
2.4–2.6 V
Foot shift switch screw
4 Nm (0.4 m·kg, 2.9 ft·lb)
®
LOCTITE
M MMM M MMM