Installing The Handlebars - Yamaha 2006 FJR1300AS Service Manual

EAS22900

INSTALLING THE HANDLEBARS

1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
2. Install:
• Handlebar grip
• Grip end "1"
M MMM M MMM M M MMM M
a. Apply a thin coat of rubber adhesive onto the
end of the left handlebar.
Recommended adhesive
Three Bond 1530
b. Slide the handlebar grip onto the left handle-
bar.
c. Wipe off any excess rubber adhesive with a
clean rag.
EWA13700
WARNING
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
NOTE:
There should be 1–3 mm (0.04–0.12 in) of clear-
ance "a" between the handlebar grip and the grip
end.
L LLL L LLL L L LLL L
3. Install:
• Right handlebar switch "1"
NOTE:
Align the projection "a" on the right handlebar
switch with the hole "b" on the right handlebar.
M MMM M M MMM M M MMM M
®
L LLL L L LLL L L LLL L
4. Install:
MMM
• Left handlebar switch "1"
NOTE:
Align the projection "a" on the left handlebar
switch with the hole "b" on the left handlebar.
5. Install:
• Hand shift switch "1"
• Lead holder 2 "2"
NOTE:
• Align the projection "a" on the hand shift switch
with hole "b" on the left handlebar.
• When installing the hand shift switch, route the
left grip warmer lead "3" and left handlebar
switch lead "4" through the switch as shown in
the illustration, making sure to fasten the left
grip warmer lead with the lead holder 2.
• After installing the hand shift switch, check that
the left grip warmer lead does not interfere with
the movement of the hand shift lever.
LLL
1
a
6. Install:
• Right handlebar
• Left handlebar
– 43 –
HANDLEBARS
b
2
4
3