Motorola CS3000 Manual page 44

Config.ini File Content (Continued)
Table 1-1
Parameter
ScanParam Variable
Sleep Integer
BTSleep Integer
ButtonPlus Enabled
Disabled
ButtonMinus Enabled
Disabled
ButtonBT Enabled
Disabled
WakeUpLED Enabled
Disabled
LEDBlue Enabled
Disabled
LEDGreen Enabled
Disabled
LEDRed Enabled
Disabled
LEDAmber Enabled
Disabled
CodeID Enabled
Disabled
ScanLED Enabled
Disabled
Values
Any scan engine parameter. Multiple
entries are allowed. Sent after reset or
when engine is powered.
For example:
ScanParam=0xf0,0x00,0x01
ScanParam=0xee,0x01
ScanParam=0x38,0x00
Time in seconds before the scanner enters
sleep mode when no activity is detected.
Time in seconds before the scanner enters
sleep mode while paired to another
Bluetooth device when no activity is
detected.
Enable or disable the Plus button.
Enable or disable the Minus button.
Enable or disable the BT button.
Enable or disable the wake-up LEDs.
Enable or disable the blue LED for normal
operation and wake up.
Enable or disable the green LED for
normal operation and wake up
Enable or disable the red LED for normal
operation and wake up.
Enable or disable the amber LED for
normal operation and wake up.
Enable or disable saving CodeID in the
scanned bar codes file. See
IDs on page
Enable or disable the LEDs that illuminate
while the laser scanner is active.
Description
Code Type
B-1.
Getting Started 1 - 27
Default
<none>
120 (2 minutes)
600 (10 minutes)
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled