Charging the Scanner Battery
To charge the CS3000 series scanner, connect it to a host PC via the USB host cable or charging cradle. No
power supply is necessary. Charge time is approximately three hours for a fully discharged battery.
NOTE To check the battery charge status, hold the scan (+) button for 15 seconds. See
Table 2-1 on page
NOTE An authorized Motorola Solutions repair facility can replace the CS3000 battery. Changing the battery
does not affect bar code data which is stored in non-volatile memory, however the date and time is lost
upon changing the battery or if the battery completely loses charge.
Charging via USB Host Cable
Insert the mini-USB connector on the host cable in the interface port on the scanner.
1.
Connect the other end of the host cable to a USB port on the host PC.
2.
Connecting Scanner to Host PC
Figure 1-4
The scanner begins charging. A complete charge of a fully discharged battery takes approximately three
hours. Charge within the recommended temperature of 32° to 104° F (0° to 40° C).
2-3.
Getting Started
1 - 3
Battery charge status
in