Wep Configuration - Canon WU10 User Manual

[WEP Configuration]

These settings are not displayed when [Network Authentication] is set
to [WPA] or [WPA2].
Name Details
Enable/disable WEP encryption
(ON/OFF).
If WEP encryption is used, wireless
communication will be encrypted
using the settings for "WEP Key 1-
4" and "Key Index".
If encryption is not enabled, data is
WEP not encrypted and is sent as is. To
ensure higher security, it is
recommended to enable
encryption when you build a
wireless network.
This setting is not displayed when
[Network Authentication] is set to
[Shared].
When using WEP encryption, set
the number of the WEP key that
you wish to use for encryption (1-
Key Index 4).
This setting must be the same as
that of the other devices (access
point, etc.) you wish to connect to.
36
Name
Default Value
OFF
WEP Key
1 - 4
1
[WPA/WPA2 Configuration]
These settings are not displayed when [Network Authentication] is set
to [Open] or [Shared].
For details on these settings, refer to "WPA/WPA2 Configuration" of
"Access Point Configuration" (p. 33).
Details
Set the encryption key (WEP key)
that you wish to use for WEP
encryption.
Up to 4 WEP keys can be set. This
setting must be the same as that of
the other devices (access point,
etc.) you wish to connect to. A
WEP key must be entered using
hexadecimal or alphanumeric
characters.
In most cases, alphanumeric
characters are used.Enter 5
characters if the key size is 64 bit
or 13 characters if the key size is
128 bit.
For hexadecimal, a value consists
of numbers (0-9) and English
letters (A-F). Enter a 10-digit value
if the key size is 64 bit or a 26-digit
value if the key size is 128 bit.
WEP Key Length
WEP Key Size
64 bit 128 bit
Hexadeci- 10 (digits) 26 (digits)
mal characters characters
Alphanu- 5 13
meric characters characters
Default Value
None