JVC KD-AV7100 Instructions Manual page 45

MISC
Menu items
TS Calibrate
3
Set Password*
Parental control
Aspect Ratio
Screen saver
4
Load Factory*
DivX Registration
Calibration
After selecting "Yes" for "TS Calibrate," the guidance for calibration appears
on the monitor as described on the right.
Touch " " which appears at each corner (A – D) in turn.
• Touch " " slowly and carefully. Touch " " repeatedly until the next
marker appears if it does not appear by touching once.
• When the unit detects that you have touched all " " accurately, the
unit exits the calibration screen.
* 1
You cannot change the "DVD Gain" setting when "DownMix" is set to "FULL 6CH." (☞ page 43)
2
* The setting for "DVD Gain" is applied also to SD and USB.
* 3
Remember your password or make a note of it. You need to enter the password to change the setting or cancel
restriction.
* 4
The settings for the clock ("Clock") and parental control ("Set Password" and "Parental control") are not
initialized.
Selectable settings, [reference page]
Correct the accuracy of the touch sensor (see "Calibration" below).
No, Yes
Enter the password (4-digit), ☞ [25]
Select the restriction level for DVD Video playback, ☞ [25]
Kid Safe (most restrictive), G, PG, PG-13, PG-R, R, NC-17, Adult (least restrictive)
Select the aspect ratio of the picture.
4:3, 16:9
Activate/deactivate the screen saver.
Off, On
Select "Yes" to reset the unit.
No, Yes
• When you select "Yes," the confirmation message appears. Select "Yes." The unit
turns off, then turn on again.
This unit has its own Registration Code. Once you have played back a file with which
the Registration Code recorded, this unit's Registration Code is overwritten for
copyright protection.
A
Please press point A at upper left corner
B
45
Initial: Underlined
D
C
SETTINGS