Installing The Battery; Installing The Cutting Units - Toro Greensmaster
3150 Operator's Manual

1
Figure 8
1. Cotter pin
9. Connect the two wire harness connectors.
10. Adjust the seat position and steering arm if necessary.
Note: To gain an additional 2.5 inches of forward
adjustment, mount seat in the front set of mounting holes in
the seat mounting plate.

Installing the Battery

1. Mount the battery with the battery terminals toward the
front of the machine.
2. Connect the positive battery cable (red) from the starter
solenoid to the positive post (+) of the battery (Fig. 9).
Secure it with a wrench and coat the terminal with
petroleum jelly. Make sure the cable will clear the seat,
in the rear-most position, which could cause wear or
damage to the cable.
Warning
Battery terminals or metal tools could short
against metal tractor components causing sparks.
Sparks can cause the battery gasses to explode,
resulting in personal injury.
• When removing or installing the battery, do not
allow the battery terminals to touch any metal
parts of the tractor.
• Do not allow metal tools to short between the
battery terminals and metal parts of the tractor.
2
2. Seat pivot rod
14
2
Figure 9
1. Negative (–)
3. Connect the black ground cable (from the engine base)
to the negative (–) post of the battery. Secure it with a
wrench and coat the terminal with petroleum jelly.
Warning
Incorrect battery cable routing could damage the
tractor and cables causing sparks. Sparks can
cause the battery gasses to explode, resulting in
personal injury.
• Always disconnect the negative (black) battery
cable before disconnecting the positive (red)
cable.
• Always connect the positive (red) battery cable
before connecting the negative (black) cable.
4. Install the battery clamp and washers and secure them
with the wing nuts.
5. Place the terminal cover over the positive (+) battery
post.

Installing the Cutting Units

For Cutting Unit Models 04610 and 04611
Note: When sharpening, setting the height-of-cut or
performing other maintenance procedures on the cutting
units, store the cutting unit reel motors in the support tubes
on the front of the frame to prevent damage to the hoses.
1. Remove the cutting units from the cartons. Assemble
and adjust them as listed in the cutting unit Operator's
Manual. Use the gauge bar from the loose parts kit to
adjust the height of cut.
1
2. Positive (+)