Positioning The Seat - Toro Greensmaster
3150 Operator's Manual

Positioning the Seat

1. Remove the locknut (Fig. 4) and seat bracket (used for
shipping) attached to the right rear seat adjuster screw
and discard them. Bracket not shown.
2
Figure 4
1. Locknut (Bracket)
2. Remove the cotter pin and seat pivot rod securing the
seat (shipping position). Remove the seat (Fig. 4).
Discard the cotter pin.
3. Remove the cotter pin securing steering arm locking
knob (Fig. 5) and remove the knob.
Figure 5
1. Steering arm locking knob
4. Cut the strap securing the steering arm to the seat frame
and pivot the steering arm to the upright operating
position.
5. Pivot the steering arm to the upright operating position
(notches). Secure with locking knob and cotter pin
(Fig. 6).
1
2. Seat pivot rod
1
13
2
Figure 6
1. Steering arm locking knob
6. Mount right step to frame with 2 self tapping screws
(Fig. 6).
7. Mount valve shield to the right side of the seat base
with 2 carriage bolts (5/16 x 5/8 in.) and nuts. Position
the shield as shown in Figure 7.
2
1
Figure 7
1. Valve shield
8. Install the seat assembly in the operating position
(Fig. 8). Install the seat pivot rod and roll pin.
Important
Make sure the pin at the rear of the seat base
snaps into the seat latch. If not, loosen the (2) seat latch
nuts and slightly reposition the latch until it can engage the
pin. Tighten the nuts to lock the adjustment.
1
2. Right step
2. Seat base