Table of Contents
Advertisement
Suspension
Front and Rear Suspension
SpecialTools
............. 18-2
Component Location Index .........................................
18-3
W h e e l A l i g n m e n t . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . 1 8 - 4
Wheel Bearing End Play Inspection ............................
18-8
Wheel Runout Inspection
..................
18-9
B a l l J o i n t R e m o v a l
. . . 1 8 - 1 0
Front Suspension
Kn uckle/H u bAVheel Bearing Replacement
Ball Joint Boot Reolacement ..................
Stabilizer Bar Rep|acement ....................
Stabilizer Link Removal/lnstallation
LowerArm Removal/lnstallation ...............
Damper/Spring Replacement
Rear Suspension
H u b B e a r i n g U n i t R e p l a c e m e n t . . . . . . . . . . . . . . . . . . . . .
Knuckle Reolacement
Stabilizer Bar Replacement ....................
Stabilizer Link Removal/lnstallation
..........................
Upper Arm Removal/lnstallation
...............
Trailing Arm Removal/lnstallation
Damper/Spring Replacement
1 8 - 1 1
1 8 - 1 6
18-17
1 8 - 1 8
1 8 - 1 9
18-20
18-26
18-28
18-30
18-31
18-32
18-33
18-34
- Quick Links:
- Ground Distribution
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the EP3 and is the answer not in the manual?
Questions and answers
Donde ba el fucible de los a/bag ind
The fuse for the airbag indicator in a Honda EP3 is the No. 10 (7.5A) fuse located in the under-dash fuse/relay box.
This answer is automatically generated
Need sequence of steps to replace the radiator fan switch "B"
To replace the radiator fan switch "B" on a Honda EP3:
1. Drain Coolant: Drain the coolant from the bottom of the radiator.
2. Access the Switch: Jack up the car. The switch is easier to reach from underneath. Use a 15/16", 22mm, or 24mm deep socket to remove it.
3. Remove the Connector: Disconnect the 2P connector from the radiator fan switch.
4. Remove the Switch: Unscrew and remove the radiator fan switch from the radiator.
5. Install New Switch: Screw in the new radiator fan switch and tighten it to 24 N·m.
6. Reconnect Connector: Reconnect the 2P connector to the new switch.
7. Refill Coolant: Refill the radiator with coolant and optionally add Redline Water Wetter.
8. Bleed Air: Bleed air from the cooling system to prevent overheating.
The process may take a few hours.
This answer is automatically generated