Table of Contents
Advertisement
Cowl Covers Replacement
1 . R e m o v e t h e w i n d s h i e l d w i p e r a r m s ( s e e p a g e 2 2 - 1 4 5 ) .
2. Remove the windshield side trim from both sides (see step 2 on page 20-19).
3. Pullthe hood rear seal (A) away from the cowl covers, then remove it, and using a clip remover, detach the clips
(B) from the cowl covers. Take care not to scratch the cowl covers.
Fastener Locations
B > r C l i p , 3 C > : C l i p , 8
:- ::::
= - --::;-:
4 . Detach the clips (C) by carefully pulling the passenger's cowl cover {D) upward, to release the hooks {E), and pull
out the cover forward to release the hooks (F), then remove the cover. Take care not to scratch the body,
Detach the clips (C) by carefully pulling the driver's cowl cover (G ) upward. and pull out the cover forward to
release the hooks (H), then remove the cover. Take care not to scratch the body.
Installthe covers in the reverse order of removal, and note these items:
. R e p l a c e a n y d a m a g e d c l i p s .
. Push the clip portions into place securely.
. Reinstall both windshield side trim properly (see step 26 on page 20-24).
20-95
- Quick Links:
- Ground Distribution
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the EP3 and is the answer not in the manual?
Questions and answers
Donde ba el fucible de los a/bag ind
The fuse for the airbag indicator in a Honda EP3 is the No. 10 (7.5A) fuse located in the under-dash fuse/relay box.
This answer is automatically generated
Need sequence of steps to replace the radiator fan switch "B"
To replace the radiator fan switch "B" on a Honda EP3:
1. Drain Coolant: Drain the coolant from the bottom of the radiator.
2. Access the Switch: Jack up the car. The switch is easier to reach from underneath. Use a 15/16", 22mm, or 24mm deep socket to remove it.
3. Remove the Connector: Disconnect the 2P connector from the radiator fan switch.
4. Remove the Switch: Unscrew and remove the radiator fan switch from the radiator.
5. Install New Switch: Screw in the new radiator fan switch and tighten it to 24 N·m.
6. Reconnect Connector: Reconnect the 2P connector to the new switch.
7. Refill Coolant: Refill the radiator with coolant and optionally add Redline Water Wetter.
8. Bleed Air: Bleed air from the cooling system to prevent overheating.
The process may take a few hours.
This answer is automatically generated