Trim Removal/Lnstallation - Hatch Area - Honda EP3 Service Manual

2002; 2003
Table of Contents

Advertisement

Trim Removal/lnstallation - Hatch Area
NOTE:
. Put on gloves to protect your hands.
. When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
. Take care not to bend or scratch the trim and panels.
1. Remove the trim in the sequence shown.
. Hatch upper trim panel
. Left hatch side trim
. Right hatch side trim
. Hatch lower trim panel
2 . I n s t a l l t h e t r i m i n t h e r e v e r s e o r d e r o f r e m o v a l , a n d r e p l a c e a n y d a m a g e d c l i p s .
Fastener Locations
A>;crip,a B>:crip,2 .>,l,l,Jil,l3 o>
3il;1,
E>:crip.2
"-{q .1
n
n
itr^
Y , ] \ . g g l f l t
O HATCH LowER TRrM
PANEL
HATCH LOWER TRIM PANEL
a- ,,) I
t7,
f .
)
a
=- -1
a
->
HATCH UPPER TRIM PANEL
HATCH SIDE TRIM
.D HATCH UPPER TRIM PANEL
20-53

Hide quick links:

Advertisement

Table of Contents

Troubleshooting

loading
Need help?

Need help?

Do you have a question about the EP3 and is the answer not in the manual?

Questions and answers

Leodan
January 22, 2025

Donde ba el fucible de los a/bag ind

1 comments:
Mr. Anderson
February 10, 2025

The fuse for the airbag indicator in a Honda EP3 is the No. 10 (7.5A) fuse located in the under-dash fuse/relay box.

This answer is automatically generated

Rafael Rodriguez
April 14, 2025

Need sequence of steps to replace the radiator fan switch "B"

1 comments:
Mr. Anderson
April 15, 2025

To replace the radiator fan switch "B" on a Honda EP3:

1. Drain Coolant: Drain the coolant from the bottom of the radiator.

2. Access the Switch: Jack up the car. The switch is easier to reach from underneath. Use a 15/16", 22mm, or 24mm deep socket to remove it.

3. Remove the Connector: Disconnect the 2P connector from the radiator fan switch.

4. Remove the Switch: Unscrew and remove the radiator fan switch from the radiator.

5. Install New Switch: Screw in the new radiator fan switch and tighten it to 24 N·m.

6. Reconnect Connector: Reconnect the 2P connector to the new switch.

7. Refill Coolant: Refill the radiator with coolant and optionally add Redline Water Wetter.

8. Bleed Air: Bleed air from the cooling system to prevent overheating.

The process may take a few hours.

This answer is automatically generated

This manual is also suitable for:

2002 ep32003 ep3

Table of Contents

Save PDF