Interior Trim
Headliner RemovaUlnstallation
NOTE:
. When prying with a flat-tip screwdriver, wrap itwith
protective tape to prevent damage.
. Take care not to bend and scratch the headliner.
. Be careful not to damage the dashboard and other
interior trim.
1. Remove these items:
. A-pillar trim, both sides (see page 20-50)
. B - p i l l a r u p p e r t r i m , b o t h s i d e s ( s e e p a g e 2 0 - 5 0 )
. Hatch weatherstrip, as necessary {see page 20-
92\
. C - p i l l a r t r i m , b o t h s i d e s ( s e e p a g e 2 0 - 5 1 )
. Moonroof switch (see page 22-'112)
. Spotlights (see page 22-961
. Ceiling light (see page 22-96)
Remove the sunvisor {A) and holder {B) from both
s r d e s .
-1 Remove the caps {C).
-2 Remove the screws.
-3 Remove the sunvisor from the body and holder.
-4 Using a flat-tip screwdriver, push the hook (D),
a n d t u r n t h e h o l d e r 9 0 ' . t h e n p u l l i t o u t .
Fastener Locations
> : Screw, 4
r(\'-r
\)*
5 x 0 . 8 m m
5 N . m
{0.5 kst m.4lbf ft}
20-54
3. From both rear passenger's, remove the caps (A),
and remove the screws, then remove the grab
h a n d l e s ( B ) .
Fastener Locations
> : Screw, 4
t , t;---iJ
)e
5 x 0 . 8 m m
4 N . m
{0.4 kgf.m, 3 lbf.ft}
Need help?
Do you have a question about the EP3 and is the answer not in the manual?
Questions and answers
Donde ba el fucible de los a/bag ind
The fuse for the airbag indicator in a Honda EP3 is the No. 10 (7.5A) fuse located in the under-dash fuse/relay box.
This answer is automatically generated
Need sequence of steps to replace the radiator fan switch "B"
To replace the radiator fan switch "B" on a Honda EP3:
1. Drain Coolant: Drain the coolant from the bottom of the radiator.
2. Access the Switch: Jack up the car. The switch is easier to reach from underneath. Use a 15/16", 22mm, or 24mm deep socket to remove it.
3. Remove the Connector: Disconnect the 2P connector from the radiator fan switch.
4. Remove the Switch: Unscrew and remove the radiator fan switch from the radiator.
5. Install New Switch: Screw in the new radiator fan switch and tighten it to 24 N·m.
6. Reconnect Connector: Reconnect the 2P connector to the new switch.
7. Refill Coolant: Refill the radiator with coolant and optionally add Redline Water Wetter.
8. Bleed Air: Bleed air from the cooling system to prevent overheating.
The process may take a few hours.
This answer is automatically generated