Table of Contents
Advertisement
Frame
Subframe Replacement
Subframe Torque
NOTE: After loosening the subframe mounting bolts, be sure to replace them with new ones.
Reference holes alignment:
SUBFRAME
REFERENCE HOLE
( B o d y S i d e )
INSTALLATION
REFERENCE HOLE
(Subframe side)
INSTALLATION
REFERENCE HOLE
FRONT SUSPENSION
SCREWDRIVER
or TAPERED PUNCH
INSTALLATION
REFERENCE HOLE
SPECIAL BOLTS
' 1 4 x 1 . 5 m m
103 N.m
(10.5 kgf.m,75lbf.ft)
R e p l a c e .
To body.
To body.
I
n
E
20-112
- Quick Links:
- Ground Distribution
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the EP3 and is the answer not in the manual?
Questions and answers
Donde ba el fucible de los a/bag ind
The fuse for the airbag indicator in a Honda EP3 is the No. 10 (7.5A) fuse located in the under-dash fuse/relay box.
This answer is automatically generated
Need sequence of steps to replace the radiator fan switch "B"
To replace the radiator fan switch "B" on a Honda EP3:
1. Drain Coolant: Drain the coolant from the bottom of the radiator.
2. Access the Switch: Jack up the car. The switch is easier to reach from underneath. Use a 15/16", 22mm, or 24mm deep socket to remove it.
3. Remove the Connector: Disconnect the 2P connector from the radiator fan switch.
4. Remove the Switch: Unscrew and remove the radiator fan switch from the radiator.
5. Install New Switch: Screw in the new radiator fan switch and tighten it to 24 N·m.
6. Reconnect Connector: Reconnect the 2P connector to the new switch.
7. Refill Coolant: Refill the radiator with coolant and optionally add Redline Water Wetter.
8. Bleed Air: Bleed air from the cooling system to prevent overheating.
The process may take a few hours.
This answer is automatically generated