Table of Contents
Advertisement
Cooling System
1 . Look at the coolant level in the reserve tank. Make
sure it is between the MAX mark (A) and MIN mark
( B ) ,
Goolant Check
lf the coolant level in the reserve tank is at or below
the MIN mark, add coolant to bring it up to the l\4AX
mark, and inspect the cooling system for leaks.
10-6
\-
Coolant Replacement
1 .
\
Start the engine. Set the heater temperature control
dial to maximum heat. then turn off the ignition
switch. Make sure the engine and radiator are cool
to the touch.
Remove the radiator cap.
Remove the splash shield (see step 23 on page 5-5).
Loosen the drain plug (A), and drain the coolant.
Remove the reserve tank drain cap (A), and drain
the coolant.
\
- Quick Links:
- Ground Distribution
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the EP3 and is the answer not in the manual?
Questions and answers
Donde ba el fucible de los a/bag ind
The fuse for the airbag indicator in a Honda EP3 is the No. 10 (7.5A) fuse located in the under-dash fuse/relay box.
This answer is automatically generated
Need sequence of steps to replace the radiator fan switch "B"
To replace the radiator fan switch "B" on a Honda EP3:
1. Drain Coolant: Drain the coolant from the bottom of the radiator.
2. Access the Switch: Jack up the car. The switch is easier to reach from underneath. Use a 15/16", 22mm, or 24mm deep socket to remove it.
3. Remove the Connector: Disconnect the 2P connector from the radiator fan switch.
4. Remove the Switch: Unscrew and remove the radiator fan switch from the radiator.
5. Install New Switch: Screw in the new radiator fan switch and tighten it to 24 N·m.
6. Reconnect Connector: Reconnect the 2P connector to the new switch.
7. Refill Coolant: Refill the radiator with coolant and optionally add Redline Water Wetter.
8. Bleed Air: Bleed air from the cooling system to prevent overheating.
The process may take a few hours.
This answer is automatically generated