Connecting Sip Cell Stations - Panasonic KX-UDS124 Installation Manual

3 Installing the SIP Cell Stations

3.2 Connecting SIP Cell Stations

Connecting a SIP-CS to a LAN
Notice
•
Connect the SIP-CSs to the LAN only after completing network settings. For details about network
settings, see "Configuring Network Settings for Air Sync Master CS" in "4.3 Site Survey".
•
When connecting a SIP-CS to the LAN, connect it to a switching hub.
Note
•
Use an Ethernet straight cable with an RJ45 connector to connect the SIP-CS to a switching hub. The
cable should be a 10BASE-T/100BASE-TX CAT 5 (Category 5) or higher cable, and the diameter of
the cable must be 6.5 mm or less.
•
It is possible to connect the SIP-CS to the LAN while registering the SIP-CS to the SIP server.
1.
Connect the cable to the SIP-CS.
2.
Pass the cable through the groove of the SIP-CS in one of the following three ways.
1 1
To a Switching Hub
3.
Connect the other end of the cable to the switching hub.
18 Installation Guide
Ethernet Cable
2 3
To a
Switching
Hub
To a Switching Hub