Table of Contents
Advertisement
54-94
FOG LIGHT
R E M O V A L A N D I N S T A L L A T I O N
Removal steps
2. Grommet
Bulb installation
L I G H T I N G S Y S T E M - Fog Light
S E R V I C E P O I N T S O F R E M O V A L
1. REMOVAL OF FOG LIGHT
The fog light assembly can be removed by pressing the
stud pin from the reverse side of the bumper.
Stud Din
R E P L A C E A B L E B U L B R E P L A C E M E N T
(1) Remove the fog light assembly, and then remove the cap.
(2) Remove the bulb installation spring, and pull out the bulb.
Caution
1. Never hold the halogen light bulb with a bare hand,
dirty glove, etc.
2. If the glass surface is dirty, be sure to clean it with
alcohol, paint thinner, etc., and install it after drying
it thoroughly.
Be sure to attach the socket cover.
NOTE
Be sure to install the socket cover securely because, if it is
not, an insecure installation could cause such problems as
clouding of the lens, or intrusion of moisture to inside the
light unit.
TSB Revision
Advertisement
Table of Contents
Troubleshooting
