Mitsubishi Electric 55624R(S)-MF Service Manual page 36

METERS AND GAUGES - Meters and Gauges
Symbol
Seat belt warning
Brake warning
BRAKE
Fuel warning
Charging warning
Oil pressure warning
Overdrive OFF indicator
Automatic transaxle-position in-
Anti-lock brake warning light
ANTI
L O C K
Check engine/malfunction indi-
CHECK
ENGINE
Auto-cruise control indicator
CRUISE
light
Operation
<Vehicles with automatic seatbelt>
This warning light warns the driver and front passenger to
fasten their seat belts. If one or more seat belts are not
fastened, the automatic seat belt control unit detects that fact
and causes the warning light to be illuminated or flash.
How long the light is illuminated or how many times it flashes
depends on whether only one, or both of the belts remain
unfastened.
The seat belt warning light will flash for about six seconds
when the ignition key is turned to the ON position.
If at this time the driver's seat belt is not buckled, the alarm
buzzer will sound four times in synchronism with the flashing
of the warning light.
This indicator comes on when the ignition key is in "ON"
position, and goes off after the engine has started. This
indicator comes on when the parking brake is applied or brake
fluid level falls less than the specific level.
This indicator comes on when the fuel in the fuel tank falls less
than approx. 8 liters (2.1 gals.).
This indicator comes on when the ignition key is in "ON"
position, and goes off after the engine has started. This
indicator comes on when the drive belt breaks or the trouble
occurs in the charging system.
This indicator comes on when the ignition key is in "ON"
position, and goes off after the engine has started. This
indicator comes on when the oil fails or the trouble occurs in
the oil circulating system while driving.
The light will light up when the overdrive switch is off.
This indicator light illuminates to indicate the position at which
the selector lever is set.
This light illuminates when the ignition switch is switched ON;
then, when the ignition key is returned from the "ST" position
to the "ON" position, it extinguishes about 0.6 second later,
thus providing a check of the anti-lock brake warning light
circuit.
This light illuminates when a malfunction is discovered in the
anti-lock braking system.
This lamp illuminates when the ignition key is turned to the
"ON" position, but should go out in a few seconds.
If the lamp illuminates while the vehicle is moving, there is a
malfunction of a component related to exhaust gases.
The light illuminates when the auto-cruise control switch is
switched ON, and the auto-cruise control system is activated.