Mitsubishi Electric 55624R(S)-MF Service Manual page 31

METERS AND GAUGES - Service Adjustment Procedures
<SOHC: U to 1992 models> i,,+ i,h+ _
P
gauge unit
connector
FUEL GAUGE SIMPLE INSPECTION
( ) Remove connector from fuel gauge unit in
I
(2) Ground the harness side connector via a test light (12V-
(3) Turn ON ignition key.
(4) Assure test light goes on and gauge needle moves.
(5) If test light goes on but gauge needle does not move,
replace fuel gauge.
If test light does not go on (and gauge needle does not
move), check fuse for broken wire, or resistance between
gauge terminals (refer to P.54-34). or break in harness.
Replace or repair defective parts.
ENGINE COOLANT TEMPERATURE GAUGE SIMPLE IN-
SPECTION
unit in engine compartment.
(2) Ground harness side connector via test light (12V-3.4W).
(3) Turn ON ignition key.
(4) Check that test light goes on and gauge needle moves.
(5) If test light goes on but the gauge needle does not move,
replace engine coolant temperature gauge.
If test light does not go on (and gauge needle does not
move), check fuse for broken wire, or resistance between
gauge terminals (refer to P.54-34), or break in harness.
Replace or repair defective part.
Revision
TSB
fuel tank.
,