JVC KW-NT1 Instructions Manual page 9

Select
<On>
when connecting
the rear view camera to the
CAMERA IN jack.
Select the reverse signal polarity
«Battery> or <GND>)
according to the connection of
your car.
Select <Auto> if your
residential area is subject to
Daylight Saving Time.
Select your residential area for
automatic clock adjustment by
GPS signal.
Select the State or Province
where you are now.
*1 *2
You can also change these settings through
<Settings>. (*1:
1&
page 70/*2:
1&
page 69)
DST*1
Camera
Input*2
Reverse
Signal
Polarity*1
TimeZone*1
State/
Province
• Finish the procedure.
• Adjust the settings.
• If you select [Skip Installation Settings
(fOlr
Store Display)],
the System starts in the
navigation demonstration mode for stores.
You need to make the installation settings
next time you turn on the power or detach the
monitor panel (then attach it).
• Whlen selecting
[Start Installation
Settings], <Demonstration>
is set to
<O'ff>.
(1&
page69)
Insta lation settings
,
• You can also select the system language
through
<Language>.
(1&
page
70)
8
Display installation settings screen.
When you turn on the unit for the first time, the initial
setup screen appears.
8
Turn on the ignition switch.
The power is turned on, and the opening screen is
displayed for about 5seconds, then the language
selection screen is displayed.
• Sele(t the language you want for the
display and the voice guidance.
9