General Prefix Code For Private Service; Static Ip Configuration - Dinstar DWG2001 User Manual

DWG Series GSM/CDMA VoIP Gateway User Manual
3.3 General feature codes for system setting
Dial numbers
*114#
*115#
*150*a#
*152*a*b*c*d#
*153*a*b*c*d#
*156*a*b*c*d#
*158#
*157
*195#
*198#
*199#
*111#
3.4 Static IP Configuration
This chapter introduces IP configuration of DWG2001/DWG2004/DWG2008 through calling IVR.
Assuming the IP address of a DWG2001/DWG2004/DWG2008 device is 172.16.0.100, subnet
mask is 255.255.0.0, IP of gateway is 172.16.0.1, configured as follows:
1) Insert a SIM card into the DWG2001/DWG2004/DWG2008 gateway
2) The configuration mode: Dial the phone number of this SIM card. hear a message, then enter
"*150*1#", hang up when hear " setting successful" message;
3) Configure IP address: Dial the phone number of this SIM card, hear a message, enter "* 152 *
Features
Play the phone NO.
Check the TT number of gateway (using just when the
device interconnects with other series of DINSTAR products)
Set IP address(static/DHCP), a can be digit 1 or 2,*150*1# is
static IP address mode, *150*2# is DHCP mode
Configure IP address, a, b, c, d are the four fields of IP
address.
Configure subnet mask. a, b, c, d are the four fields of the
subnet mask
Configure the device gateway, a, b, c, d are the four fields of
the device gateway
Report the IP address
Setting the work mode (route or bridge), * 157 * 0 # is route
mode, * 157 * 1 # is bridge mode
Play record
Clear record
Setting Record. dial*199# start record(≤ 20s), then press #
end the recording
Restart device
Table 3‐1 Feature codes for system setting
12