Chapter 3 Network Configuration; Preparation; Attentions - Dinstar DWG2001 User Manual

DWG Series GSM/CDMA VoIP Gateway User Manual
Chapter 3 Network configuration
In this chapter we will introduce the initial configuration of DWG2001/DWG2004/DWG200
gateway. All of the network parameters of the gateway can be configured by IVR guidance.
3.1 Preparation
Please ensure the following stepes are done properly before IVR setting:
1) Prepare an analog telephone or mobile phone
2) Make sure the gateway is power on
3) Make sure the gateway is connected with the network
4) Completed the SIM installation
5) Make sure that the current mobile network is working
3.2 Attentions
In each step, if user hears an IVR message of "setting successful", which means that user has
finished this step successfully. However, if user hears a "setting failed" message, please check
redo theatstep again.
DWG2001/DWG2004/DWG2008 can work in two modes: route mode and bridge mode. when the
gateway is under bridging mode, user should configure network parameters of WAN port; when
the gateway is under the route mode, user should configure LAN port.
11