Action At An Alarm Occurrence; Alarm Type - Panasonic WV-SW390 Series Operating Instructions Manual

4 Action at an alarm occurrence

The alarm action (camera action at an alarm occurrence) will be performed when the following alarms occur.

4.1 Alarm type

•
Terminal alarm: When connecting an alarm device such as a sensor to the EXT I/O connectors 1-3 of the
camera, the alarm action will be performed when the connected alarm device is activated.
•
VMD alarm: When motion is detected in the set VMD area, the alarm action will be performed.
*VMD stands for "Video Motion Detection".
•
Command alarm: When a Panasonic alarm protocol is received from the connected device via a network,
the alarm action will be performed.
•
Auto track alarm
performed in the auto tracking operations.
4.2 Action at an alarm occurrence
Display the alarm occurrence indication button on the "Live" page
The alarm occurrence indication button will be displayed on the "Live" page at an alarm occurrence.
(®page 10)
IMPORTANT
•
When "Polling(30s)" is selected for "Alarm status update mode" (®page 49), the Alarm occurrence
indication button will be refreshed in 30-second intervals. For this reason, it may take a maximum of
30 seconds until the alarm occurrence indication button is displayed on the "Live" page at an alarm
occurrence.
Notify of alarm occurrences to the device connected to the alarm connector
It is possible to output signals from the alarm connector on the rear of the camera and sound the buzzer when
an alarm occurs. The settings for the alarm output can be configured in the "Alarm output terminal setup"
section of the [Alarm] tab of the "Alarm" page. (®page 129, page 136)
Save images on the SD memory card
When an alarm occurs, images (JPEG/H.264) will be saved on the SD memory card. The settings to save
images on the SD memory card can be configured on the [SD memory card] tab of the "Basic" page
(®page 54) and the [Alarm] tab of the "Alarm" page. (®page 133)
Transmit an image onto a server automatically
An alarm image can be transmitted at an alarm occurrence to the server designated in advance. The settings
required to transmit an alarm image to a server can be configured in the "Alarm image" section on the
[Alarm] tab of the "Alarm" page (®page 133) and the [FTP] tab (®page 156) of the "Server" page.
: According to the conditions set in advance, the alarm action will be
SW396 SC386
4 Action at an alarm occurrence
Operating Instructions 29