11 Configure the settings relating to images and audio [Image/Audio]
•
Outdoor scene: Depending on the brightness level (illuminance), the iris will automatically be controlled
together with the shutter speed adjustment to control light. When shooting a bright subject such as outdoor,
etc., select this parameter. Be aware that flicker may occur when a subject is under fluorescent lighting.
•
Indoor scene (60 Hz) / Indoor scene (50 Hz): The shutter speed will automatically be adjusted to prevent
flicker caused by fluorescent light. Select 50 Hz or 60 Hz corresponding to the location where the camera
is in use.
•
Fix shutter: The selected value will be set as the fixed shutter speed.
1/30 Fix, 3/100 Fix, 3/120 Fix, 2/100 Fix, 2/120 Fix, 1/100 Fix, 1/120 Fix, 1/250 Fix, 1/500 Fix, 1/1000 Fix,
1/2000 Fix, 1/4000 Fix, 1/10000 Fix
•
Default: Outdoor scene
Note
•
When a faster shutter speed is selected (up to 1/10000), it is possible to capture a fast moving object
with less blur.
•
When a faster shutter speed is selected, the sensitivity will become lower. Smear also may appear
under bright light condition.
•
When "On" is selected for "Wide dynamic range", only "Outdoor scene", "Indoor scene (60 Hz)" and
"Indoor scene (50 Hz)" are available.
[AGC]
Select a method of gain adjustment from the following.
•
On(High)/On(Mid)/On(Low): When the luminance of the subject becomes darker, gain will be
automatically incremented and screen will become brighter. "High", "Mid" and "Low" are indications of gain
level.
•
Off: Images will be captured with the fixed gain level.
•
Default: On(High)
[Auto slow shutter]
The electronic sensitivity enhancement (sensitivity up) can be carried out by adjusting the storage time of the
sensor.
The following are available for the recording duration.
Off(1/30s), Max.2/30s, Max.4/30s, Max.6/30s, Max.10/30s, Max.16/30s
•
Default: Off(1/30s)
IMPORTANT
•
When "On" is selected for "Auto slow shutter", frame rate may become lower. Noise or white dots
(blemishes) may sometimes appear.
Note
•
When "Max. 16/30s" is selected, for example, sensitivity will automatically be increased up to x16.
When "Off" is selected for "AGC", this setting is unavailable.
[Day & Night(electrical)]
Select switching between the color mode and the black & white mode from the following.
•
Off: The color mode is selected.
•
Auto: Switches from color to black-and-white images when the ambient brightness (illuminance) of the
camera is approx. 1.0 lx or less. It takes time to switch between modes.
•
Default: Off
[White balance]
Select a method of white balance adjustment from the following.
White color can be adjusted by "Red gain" and "Blue gain".
104
Operating Instructions