Setting Of Alarm; Setting Of Motion - Samsung SDM-160 User Manual

Digital Multiplexer

5. Setting of alarm

Set operation when alarm occurs.
The following screen is displayed if pressing the "ENTER" button with the blinking indication placed at the
"5.ALARM SET" by pressing the "MOVE" button on the main menu screen:
- The blinking character moves if pressing "
- The setting value is changed if pressing "
HOLD TIME : 00 ~ 30 (MIN)
The 00 MIN 00 SEC means a manual mode (perform operation for the time the alarm input enters into).
REC TYPE: NOR
¥ Set a record mode when alarm occurs.
ALARM INPUT: OFF
¥ Set according to the output of alarm sensor connected to the alarm input terminal on the rear side of this unit.
¥ OFF: When no alarm input exists.
¥ N.O: When alarm input is ACTIVE LOW.
¥ N.C: When alarm input is ACTIVE HIGH.
- The changed setting value is stored if pressing the "SET" button and you can return to the main menu.

6. Setting of motion

Set motion detection and operation.
The following screen is displayed if pressing the "ENTER" button with the blinking indication placed at the
"6.MOTION SET" by pressing the "MOVE" button on the main menu screen:
[ALARM SET]
HOLD TIME 01 MIN
00 SEC
REC TYPE NOR
ALARM INPUT OFF
", "
", "
00 ~ 59 (SEC)
TL V
N.O N.C OFF
[MOTION SET]
SENSITIVITY
AREA SET
ALARM OUT
LIST UPDATE
BUZZER
5-7
" button.
" button.
OFF
CH1...
OFF
OFF
OFF