Table of Contents
Advertisement
Digital Multiplexer
CHAPTER 2. INSTALLATION
Preparing for the Installation
The following information is prepared for safe installation of the unit.
This unit can be placed on a flat table or installed in the rack. It should not be used vertically or skew, but
horizontally. The location of the unit and the composition of wiring are very important in properly operating
the system. When equipment is placed too close or if ventilation is not properly done, system may not
work properly, and maintenance of the system may be difficult. In order to prevent system failure and to
reduce system shut-down by outside environmental factors, air circulation in the system operating room,
and the cover of the unit must be fixed. Do not open the cover voluntarily because high voltage within the
unit may cause electric shock.
PHYSICAL & ENVIRONMENTAL
¥ Operating Temperature : 0
¥ Maintenance Temperature : -20 °C to 60 °C
¥ Operating Humidity : 20% to 85% (RH)
¥ Maintenance Humidity : 20% to 95% (RH)
¥ Power Supply : 100 ~ 240 VAC
¥ Power Consumption : less than 14W
¥ Frequency : 50 / 60 Hz
CAUTIONS
When system is operated, input voltage range must be within 10% of nominal voltage, and power consent
should be grounded. Heating devices such as hair dryer, iron, refrigerator should not be used together.
For safe power supply, AVR (Automatic Voltage Regulator) is recommended.
The connector linked to this equipment can affect EMI, so it is recommended to coil the CORE-FERRITE
for use.
°C to 40 °C
2-1
Advertisement
Table of Contents
