Table of Contents
Advertisement
ASSEMBLY & OPERATING INSTRUCTIONS
WARNING:
splitter. Follow the safety instructions in the manual and in decals attached
to the product. Failure to do so could result in serious injury or death.
LS126-811-0411
Rev. 3
22 TON VERTICAL/HORIZONTAL
MODEL NO.
S40123300 & S401233CA
Owner's Manual
All operators must read this manual before operating this log
LOG SPLITTER
Advertisement
Table of Contents
Related Manuals for SpeeCo SplitMaster S40123300
Summary of Contents for SpeeCo SplitMaster S40123300
- Page 1 22 TON VERTICAL/HORIZONTAL LOG SPLITTER MODEL NO. S40123300 & S401233CA Owner’s Manual ASSEMBLY & OPERATING INSTRUCTIONS WARNING: All operators must read this manual before operating this log splitter. Follow the safety instructions in the manual and in decals attached to the product. Failure to do so could result in serious injury or death.
-
Page 2: Table Of Contents
Table of Contents Page(s) Important Safety Information......................... Intended Use ......................... Personal Protective Equipment ....................Safety Decals ........................General Safety ........................Work Area ..........................Preparation of the Log ....................... Operation of the Log Splitter ....................General Repair ........................Maintenance & Safety ......................Fire Prevention ........................ -
Page 3: Important Safety Information
BEFORE operating this log splitter, make sure that you wear safety gear such as goggles or safety glasses, steel toed shoes and tight fitting gloves (without loose cuffs or draw strings). Always wear a protective hearing device when operating this log splitter. SAFETY DECALS Make sure that all safety warning decals are in good condition and readable. Always replace missing or defaced decals. Contact SpeeCo at 1-800-525-8322 for replacement decals. PART NUMBER: S52062500, LOCATION: TOP, FRONT END OF TONGUE Page 1... - Page 4 PART NUMBER: S52062200 LOCATION: TOP OF CYLINDER PART NUMBER: S52062300 LOCATION: STRIPPER PLATE, OPERATOR SIDE PART NUMBER: S52062600 LOCATION: STRIPPER PLATE, NON OPERATOR SIDE PART NUMBER: S52062400 LOCATION: HYDRAULIC TANK LOWER TANK, RIGHT CORNER PART NUMBER: S52062100 LOCATION: TOP OF HYDRAULIC CYLINDER Page 2...
-
Page 5: General Safety
GENERAL SAFETY ALWAYS keep the operator’s manual nearby for reference. Reread the manual periodically. ALWAYS keep all bystanders and pets a minimum of 10 feet away from your work area when operating this log splitter. Only the operator is to be near the log splitter during use. NEVER allow adults lacking proper instructions and understanding to operate this log splitter. -
Page 6: General Repair
ALWAYS block the wheels to prevent movement of the log splitter while in operation. KNOW how to stop the log splitter and disengage the controls before operating it. NEVER place hands or feet between the log and splitting wedge during forward or reverse stroke as this could result in serious injury or death. -
Page 7: Maintenance & Safety
MAINTENANCE & SAFETY The hydraulic system of your log splitter requires careful inspection along with the mechanical parts. Be sure to replace frayed, kinked, cracked or otherwise damaged hydraulic hoses or hydraulic components. NEVER check for leaks of hydraulic fluid with your hand. Fluid escaping from a small hole can be almost invisible. Escaping fluid under pressure can have sufficient force to penetrate skin causing SERIOUS INJURY or even DEATH. Leaks can be safely detected by passing a piece of cardboard over the suspected leak and looking for discoloration. NEVER remove the cap from the hydraulic tank or reservoir while the log splitter is running. The tank could contain hot oil under pressure which could result in serious injury. -
Page 8: Towing Safety
IMPORTANT NOTE – (spark arrester): As a precautionary measure against possible flying sparks, always take a Class B fire extinguisher with you when operating this log splitter in dry areas. This log splitter is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). -
Page 9: Assembly Instructions
ASSEMBLY INSTRUCTIONS NOTE: This log splitter was partially assembled at the factory. To complete assembly, follow the step-by-step instructions below through page 9. Refer to the drawings and replacement parts list should it become necessary to disassemble the unit for repair or replacement of parts. - Page 10 STEP 3: Attach the tongue assembly (5) to the tank assembly (4) using two 1/2” NC x 4-1/2” hex cap bolts (1), two 1/2” lock washers (2) and two 1/2” hex nuts (3). Tighten. ITEM NO DESCRIPTION QTY. 1/2” NC x 4-1/2” Bolt 1/2” Lock Washer 1/2”...
-
Page 11: Replacement Parts
STEP 5: Connect the end of the 1/2” ID x 44” hydraulic pressure hose (1) coming from the fitting on the pump to the fitting on the valve. See illustrations below. STEP 6: Slide one hose clamp on the end of the 3/4” x 44” hydraulic return hose (3) that comes from the fitting on the filter. Then connect the hose to the fitting on the valve. See illustrations below. ITEM NO. DESCRIPTION QTY. View from Top 1/2” x 44” Pressure Hose Worm Gear Clamp 3/4” x 44” Return Hose Auto-Return Valve Area of Detail REPLACEMENT PARTS TANK/ENGINE ASSEMBLY BREAKDOWN ITEM NO. PART NO. DESCRIPTION QTY. -
Page 12: Replacement Parts
BEAM ASSEMBLY BREAKDOWN ITEM NO. PART NO. DESCRIPTION QTY. 1/2” X 3-1/4” GR5 Hex Cap Bolt 1/2” Regular Lock Washer 1/2” Hex Nut S401411R0 Beam S40141700 Wedge S390118BC 4” Cylinder S07073100 Cylinder Pin S390406SC Valve S39034700 1/2” Pipe to Steel Tube Fitting S39034300 1/2”... -
Page 13: Operating Instructions
OPERATING INSTRUCTIONS WARNING: Be sure to read the IMPORTANT SAFETY INFORMATION at the beginning of this manual before operating the log splitter. Si no entiende ingles, se prefiere que busque alguien que interprete las instrucciones para usted. This log splitter must be filled with hydraulic oil and engine oil before operation. Please follow the instructions below IMPORTANT: for filling the hydraulic tank. -
Page 14: Operation
OPERATION WARNING: See safety information related to operation of the log splitter on page 3 and 4 of this manual. Make sure that you are wearing the recommended personal protective equipment described on page 1. 1) Set up the log splitter in a clear, level area and block the wheels. Make sure that the suction port on the tank is always on the lower side of the log splitter. -
Page 15: Warranty/Service Contact
IMPORTANT NOTICE We, the manufacturer, reserve the right to change the product and/or specifications in this manual without notification. The manual is for information usage only and the pictures and drawings depicted herein are for reference only. NOTES Warranty Repair and Service Do not return this product to the store for warranty issues or repair. Call 1-800-525-8322 for the location of the nearest service center. -
Page 16: Specifications
SPECIFICATIONS MODEL NO. S40123300 & S401233CA MAXIMUM SPLITTING FORCE* 22 Tons* ENGINE 190cc 675 Series Briggs & Stratton Engine CYLINDER 4” Diameter X 24” Stroke VALVE Auto-Return PUMP Two-Stage 11 gpm MAXIMUM LOG LENGTH 25” CYCLE TIME * 13 Seconds 4.80 X 8” Pneumatic Tires WHEELS...
Need help?
Do you have a question about the SplitMaster S40123300 and is the answer not in the manual?
Questions and answers