22 ton vertical/horizontal log splitter (17 pages)
Summary of Contents for SpeeCo LS401213
Page 1
MODEL NO. LS401221 22 TON Owner’s Manual ASSEMBLY & OPERATING INSTRUCTIONS MODEL NO. LS401213 28 TON This safety alert symbol identifies important safety messages in this manual. Failure to follow this important safety information may result in serious injury or death.
Si no entiende ingles, se prefiere que busque alguien que interprete las instrucciones para usted. INTENDED USE NEVER use this log splitter for any other purposes than splitting wood. It is designed for this use only. Any other use can cause serious injury or death.
Page 4
PART NUMBER: DL51-1-32 LOCATION: TOP OF HYDRAULIC CYLINDER Page 2 PART NUMBER: DL51-1-57 LOCATION: TOP, FORWARD SECTION OF HYDRAULIC CYLINDER PART NUMBER: DL51-1-86 LOCATION: CLEVIS END OF BEAM NEAR TILT LOCKING PIN 28 TON AND 34 TON MODELS ONLY PART NUMBER: DL52-2-14 LOCATION: TOP, FRONT END OF TONGUE...
NEVER operate the log splitter on slippery, wet, muddy or icy ground. ONLY operate your log splitter on level ground. Operating on a slope could cause the log splitter to roll over or logs to fall off. NEVER operate your log splitter in an enclosed area. Exhaust fumes contain carbon monoxide which can be deadly when inhaled.
ALWAYS use your hand to operate the control lever on the valve. NEVER use your foot, a rope or any extension device. NEVER move the log splitter while the engine is running. Shut off the engine even if you are leaving the log splitter for a short period of time.
ALWAYS use an approved fuel container. ALWAYS replace the gas cap securely. If gasoline has spilled, move the log splitter away from the area of the spill and avoid creating any source of ignition until the spilled gas has evaporated.
NEVER exceed 45 mph when towing your log splitter. Towing the log splitter at speeds higher than 45 mph could result in loss of control, damage to the equipment, serious injury or death. Adjust towing speed for terrain and conditions. Be extra cautious when towing over rough terrain especially railroad crossings.
EMBLY INSTRUCTIONS NOTE: The following instructions pertain to four SpeeCo log splitters, the 22 ton (LS401221), 25 ton (LS401216), 28 ton (LS401213) and the 34 ton (LS401224). The four models share most of the component parts. Any differences are noted in the parts list and assembly instructions.
“OK” range. Do not fill beyond the “OK” range on the dipstick. STARTING INSTRUCTIONS Refer also to the Engine Operating and Maintenance Instructions manual for your particular log splitter. 1) 25 Ton, 28 Ton and 34 Ton Models with 10.5 h.p. Engine a) Move the throttle lever to “FAST”.
1. 1) Set up the log splitter in a clear, level area and block the wheels. Make sure that the suction port on the tanks is always on the lower side of the log splitter.
Model No. ____________________ Date of Purchase _______________ NOTES Serial No. _____________________________ Place of Purchase _______________________ _______________________ _______________________ _______________________ Page 13...
SPECIFICATIONS . P . " 4 " 7 h t i " 2 " 2 * Ideal case cycle times. Actual cycle times will vary depending on temperature, altitude, engine speed, pump efficiency, etc. . P . g i r &...
Need help?
Do you have a question about the LS401213 and is the answer not in the manual?
Questions and answers