GE MDS 4790M Installation And Operation Manual page 68

Set Owner
Message
S e t Own er Me s sa ge
Set Time
Se t Tim e
1 2: 0 4: 0 3 A M
May 01 199 9
Set Date
Set Date
1 2:0 4:03 A M
Ma y 01 1 99 9
60
• Continue in this way, using the up/down arrow buttons to move the
underscore to a character, then pressing the right arrow button to move to the
next character position.
• Press ENTER to save the owner name.
Figure 25. Setting the Owner Name and Message
This screen is used to set or display text (up to 20 characters) to appear on the
radio's start-up screen, such as the site name. See the Set Owner Name command
and Figure 25 above for instructions.
This screen is used to set or display the time set in the radio. The accuracy of the date
and time are important, because event codes are "stamped" with the date and time.
To change the time, press ENTER, then use the left/right arrow buttons to select
the hour, minute, second, or AM/PM. Then use the up/down arrow buttons to
increase or decrease the digit, or toggle between AM and PM. Repeat for other
characters if necessary. Press ENTER again to make the change.
This screen is used to set or display the date set in the radio. The accuracy of the date
and time are important because event codes are "stamped" with the date and time.
To change the date, press ENTER, then use the left/right arrow buttons to select
the month, day, or year. Then use the up/down arrow buttons to increase or
decrease the day or year, or set the month. Repeat for other characters if
necessary. Press ENTER again to make the change.
MDS 4790M (MPT 1411) I/O Guide
OWN [xxxxx] command, page 37
OWM [xxxxx] command,
page 37
TIME [hh:mm:ss] command,
page 43
DATE [mmm dd yyyy]
command, page 33
MDS 05-3628A01, Rev. B