NEC Express5800/R120b-1 User Manual page 79

3-16 Setting Up Your Server
Removing Rail Assemblies
Remove the rail assembly from the 19-inch rack in the following procedure.
1.
Remove the server from the rack according to "Removing the Server" described earlier.
2.
Prepare the tool to remove the sliding rail (outer rail). The tool is provided with your
server.
3.
Insert the tool into the angle hole at the front of rail assembly, as shown in the figure
below.
Observe the following instructions to use the server safely. Failure to follow
these instructions may cause a fire, personal injury, or property damage. See
pages 1-4 to 1-11 for details.
Do not install/remove the server in/from the rack only by a single person.
Do not pinch your finger with mechanical components.
Do not apply any load on the server being pulled out from the rack.
Do not pull out a device from the rack if the rack is unstable.
Do not leave more than one device being pulled out from the rack.
Do not pull out the server from the rack while it is operating.
Angle hole
CAUTION