NEC Express5800/R120b-1 User Manual page 409

9.
Insert the riser module assembly into the slot on the motherboard.
Align the riser card terminal section with the slot on the motherboard, and firmly push the
riser module until it is fully seated.
NOTES:
There are catches on the riser card frame that are used to secure the riser card to
the cabinet. When inserting the riser card, confirm that the catches are correctly fit
into the holes on the rear of the cabinet. After the insertion, push the riser card
with your fingers until you cannot see any part of the riser card terminal section.
The riser card is now fully seated in the slot.
Pay attention not to damage the components on motherboard with the riser card
when inserting it into the slot.
10.
Use screws to fix the riser card in place.
11.
Install the components you removed previously.
12.
Verify that POST displays no error messages.
If POST displays an error message, take a note on the message and see the POST error
messages listed on page 8-10.
13. Run the BIOS SETUP utility and select "Yes" for [Advanced] → [Memory
Configuration].
This setting is required to update the hardware configuration information. See page 4-8 for
details.
Removal
Remove a PCI card in reverse order of the installation steps. After removal, use the [Boot] menu of
the BIOS setup utility to set the boot order (as described on page 4-33).
Upgrading Your Server 9-53