NEC Express5800 User Manual page 52

2-20 General Description
5.
If the server has an optional RAID controller, POST displays the message prompting you
to launch the WebBIOS Setup utility. (POST will automatically proceed a few seconds
later.)
Press <Ctrl><H> for WebBIOS
Press Ctrl + H to run the utility to configure the RAID System with hard disk drives. For
detail explanation, see Chapter 4 for detail.
When you exit the utility, a message prompting you to restart the system. Press Ctrl + Alt
+ Del. The server automatically restarts POST all over again.
6.
If the POST detects the optional add-in card, it displays the message prompting you to
launch the add-in card BIOS configuration utility. (You can ignore the message. POST
will automatically proceed a few seconds later.)
<Example: SCSI BIOS setup utility>
Press <Ctrl> <A> for SASSelect(TM) Utility!
Press Ctrl + A to run the utility. Refer to the manual that comes with the optional add-in
card for detail.
7.
After a while, POST displays the following message prompting you to launch the BIOS
SETUP utility, stored in the mother board of the server. This message appears at bottom
left on the screen.
Press <F2> to enter SETUP
Launch the BIOS SETUP utility when you need to change the settings to meet the
requirements for the server. As long as the above message is not displayed with an error
message, you don't have to launch the utility. (Ignore the message. POST will
automatically proceed.)
To launch the BIOS setup utility, press F2 while the above message is displayed. See
Chapter 4 for setup and parameters.
The server automatically restarts POST all over again when you exit the SETUP utility.
8.
If you set a password using the BIOS SETUP utility, the password entry screen appears
upon successful completion of POST.
Up to three password entries will be accepted. Three incorrect password entries disable
the server to boot. In such a case, turn off the power and wait about ten seconds before
turning on to boot the server.
IMPORTANT:
9.
The OS starts when POST completes.
Do not set a password before installing an OS.