Figure 4-4 Floor-Mounting Installation: Vertical Joining - Panasonic DBS 576 Technical Manual

Section 300-Installation
Figure 4-4. Floor-mounting Installation: Vertical Joining
6. Attach the other Base Cabinet, Expansion Cabinet-1 and Expansion Cabinet-2
7. Attach the 12 Horizontal Joint Plates (front: 6, rear: 6) onto the front and rear
8. Drill 4 four holes in the floor to attach the cabinet to the floor, and drive in hole-
Note:
Base Cabinets. Before drilling the holes check the drilling hole pitch referring to
Figure 4-4.
9. Place the cabinet close to the wall.
576-13-300
following steps 2 to 5.
sides of each of the left and right cabinets with 24 screws. (The Horizontal Joint
Plates are part of the VB-44024 expansion braket kit and must be separately
purchased.)
in-anchors.
4 holes should be drilled in the floor on both sides of the joined left and right
DBS 576 (USA), issued 6/2/98
Chapter 4. - Installing Additional Cabinets
4-5