Sharp CD-G14000 Operation Manual page 40

CD-G14000
Recording on a cassette tape (continued)
CD-G17000
CD-G22000
ENGLISH
To perform programmed recording:
1 Programme discs and tracks. (See page 26.)
2 Press the button.
3 Press the / (TAPE
To stop recording:
Press the (TAPE ) button.
The disc and tape will stop.
Recording from the radio
1
Tune in to the desired station. (See page 31)
2
Load a cassette into the TAPE 2 cassette compartment
with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the button.
Recording will be paused.
4
Press the /
To interrupt recording:
Press the button.
To resume recording, press the
To stop recording:
Press the (TAPE ) button.
Note:
If you hear a whistling noise whilst recording an AM station, move the
AM loop aerial.
E-36
) button.
(TAPE ) button to start recording.
/ (TAPE ) button.
Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette
into the TAPE 1 cassette
compartment. Insert a blank
tape into the TAPE 2 cassette
compartment.
It is recommended that the recording tape is the same length as
the master tape.
3
Press the TAPE (1 2) button until "TAPE 1" appears on
the display.
4
Press the button.
Recording will be paused.
5
Press the / (TAPE ) button to start dubbing.
To stop dubbing:
Press the (TAPE ) button.
TAPE 1 and TAPE 2 will stop simultaneously.
Erasing recorded tapes
1 Load the tape to be erased into the TAPE 2 cassette
compartment with the side to be erased facing towards you.
2 Press the TAPE (1 2) button until "TAPE 2" appears on the
display.
3 Press the button.
4 Press the / (TAPE ) button to start erasing.
Note:
Make sure that the TAPE 1 is not in use.
5
CD
4
3
PRESET
2
PRESET
1
TUNING
VOL.
TUNING — VOL.
PHONES
TAPE 1 TAPE 2