General Control - Sharp CD-G14000 Operation Manual

CD-G14000
Subwoofer control (continued)
CD-G17000
CD-G22000
ENGLISH
Before you turn the system on/off on the main unit, minimise the
speaker volume on the main unit and turn the VOLUME control of
the subwoofer to "–".
Subwoofer light up
The subwoofer unit surface will light up and blink according to BASS
SOUND LEVEL.
During STAND-BY MODE (demo mode):
When subwoofer is turned ON, the subwoofer unit will emit blinking
light.
During STAND-BY MODE (low power consumption mode):
When subwoofer is turned ON, no light will be emitted from the
subwoofer unit.
Notes:
Observe the following to avoid malfunction and sound distortion.
Do not set the volume too high on the main unit. The subwoofer
may be damaged.
Before you switch on/off on the main unit, minimise the volume on
the main unit.
Unplug the AC power lead when connecting the subwoofer cable.
E-18

General control

5
4
3
2
1
TIMER
POWER
ON/ STAND-BY
CD
TAPE
(1 2)
TUNER
(BAND)
PRESET
AUDIO
IN
TUNING
VOL.
To turn the power on
Press the ON/STAND-BY button to turn the power on.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
Display brightness control
To dim the display brightness, hold down the CLEAR/DIMMER
button on the remote control for 2 seconds or more.
Volume auto fade-in
If you turn off and on the main unit with the volume set to 27 or
higher, the volume starts at 16 and fades in to the last set level.
REMOTE
SENSOR
OPEN/
c
CLOSE
5
4
3
PRESET
2
1
TUNING
VOL.
VOL. VOL.
—